WOODCRAFT 36mm EX500 87-93, Ninja 250 up to 07 Clipon Towers

Woodcraft 3-piece split clipons are specially designed to make installation and removal a snap. Our 3-piece design is race proven and makes it easy to service your clipons below the triple clamp without having to disassemble the entire front end. Special attention has also been taken to save weight wherever possible.

These clipon towers bolt right on in the stock location with no interference on the tank, fairings or gauges. They're lower than the OEM bars (about 1.5 inches on the Ninja 250 and 3 inches on the older EX500) and also have a comfortable 5 degree down angle instead of the completely flat OEM setup.

Racers and street riders alike have used these bars for years to give these bikes a much sportier feel. You will also get the added benefit of width adjustment and access to inexpensive replacement handlebars.